Moreover, I plugged the old drive back in and also the new one through USB. The startup opened up the automatic repair which didn't succeed. I unplugged the old hard drive and plugged in the new one. I cloned the drive using software provided by the SSD card (Acronis True Image). My previous one was a ST3500413AS ATA Seagate Barracuda 512 GB HDD from the year 2012 or earlier. I can now reboot my laptop on the Samsung SSD without issue.I bought recently an SSD hard drive (Crucial MX500 1TB 3D NAND SATA 2.5-inch 7mm (with 9.5mm adapter) Internal SSD CT1000MX500SSD1). Then run the bcdboot command to correct the boot loader I removed the wrong drive letter and added the correct one: I then selected my Windows Partition (your volume number may be different): I removed the drive letter from the recovery partition by selecting the volume number (your volume number may be different): In looking at the labels, I noticed that the recovery partition had been assigned drive letter C and my Windows Partition was letter D. Go to Troubleshoot > Advanced options > Command Prompt To fix this:īoot to Recovery mode (Windows install media > Repair your computer option) Similar to user1247736 I found that the partition where Windows was installed was not C anymore. I had this issue too, I cloned my disk to a Samsung EVO 870 and it would boot one time then fail. For example, if Windows is detected on "D:\Windows", then run: bcdboot D:\WindowsĬ) If the boot partition (UEFI partition) is on a different drive than the one where Windows is installed on, then adjust the drive specified to the /s option accordingly. The bootrec /scanos command should help with that. Run the bcdboot command in one of the following ways:Ī) If your system has only one drive/disk, run: bcdboot c:\windowsī) Otherwise, figure out the drive letter where Windows is installed on. Go to Troubleshoot > Advanced options > Command Prompt (see screenshots in link above) For example screenshots, refer to the "Solution 2" section at. However, when prompted, instead of clicking the "Install Now" button, choose the "Repair your computer" option. This is essentially the same answer as but with more background details.Ĭreate Windows installation media per Microsoft's documentation.īoot into Windows Installer. I had the same issue after I cloned an SSD drive. How can I repair this installation? The source disk is GPT and the SSD is a Samsung 850 EVO. I tried doing an upgrade installation of Windows and it says it can't upgrade without having an existing installation. When I select Yes(Y) I get an error that says: The system cannot find the path specified. When I run bootrec /fixboot I get an error that says Access is deniedĪnd when I try to run bootrec /rebuildbcd it sees my installation and asks if I want to add the installation to the boot list. I tried going into the command line repair tool and I ran bootrec /FixMBR and it apparently runs successfully and it says: The operation completed successfully I tried to run Startup Repair but it fails and says: Automatic Repair couldn't repair your PC. When I try to boot I get a blue screen that says: Recovery Your PC/Device needs to be repaired A required device isn'tĬonnected or can't be accessed. I used AOMEI Backupper to clone my original drive to a new SSD.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |